For 64-bit ARM, A64 (from Procedure Call Standard for the ARM 64-bit Architecture)

There are thirty-one, 64-bit, general-purpose (integer) registers visible to the A64 instruction set; these are labeled r0-r30. In a 64-bit context these registers are normally referred to using the names x0-x30; in a 32-bit context the registers are specified by using w0-w30. Additionally, a stack-pointer register,SP, can be used with a restricted number of instructions.

• SP The Stack Pointer
• r30 LR The Link Register
• r29 FP The Frame Pointer
• r19…r28 Callee-saved registers
• r18 The Platform Register, if needed; otherwise a temporary register.
• r17 IP1 The second intra-procedure-call temporary register (can be used by call veneers and PLT code); at other times may be used as a temporary register.
• r16 IP0 The first intra-procedure-call scratch register (can be used by call veneers and PLT code); at other times may be used as a temporary register.
• r9…r15 Temporary registers
• r8 Indirect result location register
• r0…r7 Parameter/result registers

The first eight registers, r0-r7, are used to pass argument values into a subroutine and to return result values from a function. They may also be used to hold intermediate values within a routine (but, in general, only between subroutine calls).

Registers r16 (IP0) and r17 (IP1) may be used by a linker as a scratch register between a routine and any subroutine it calls. They can also be used within a routine to hold intermediate values between subroutine calls.

The role of register r18 is platform specific. If a platform ABI has need of a dedicated general purpose register to carry inter-procedural state (for example, the thread context) then it should use this register for that purpose. If the platform ABI has no such requirements, then it should use r18 as an additional temporary register. The platform ABI specification must document the usage for this register.

SIMD

The ARM 64-bit architecture also has a further thirty-two registers, v0-v31, which can be used by SIMD and Floating-Point operations. The precise name of the register will change indicating the size of the access.

Note: Unlike in AArch32, in AArch64 the 128-bit and 64-bit views of a SIMD and Floating-Point register do not overlap multiple registers in a narrower view, so q1, d1 and s1 all refer to the same entry in the register bank.

The first eight registers, v0-v7, are used to pass argument values into a subroutine and to return result values from a function. They may also be used to hold intermediate values within a routine (but, in general, only between subroutine calls).

Registers v8-v15 must be preserved by a callee across subroutine calls; the remaining registers (v0-v7, v16-v31) do not need to be preserved (or should be preserved by the caller). Additionally, only the bottom 64-bits of each value stored in v8-v15 need to be preserved; it is the responsibility of the caller to preserve larger values.